Elora Ash Wood Square End Table in Jet

Elora Puts a Rounded Square Top on Two Arched Slab Legs

Dimensions	24″w x 22″d x 22″h
Materials	Mahogany solid wood and ash wood veneer
Finish	Jet, dark wire brushed NC lacquer with the ash grain visible
Weight	75 lb
Weight capacity	138 lb
Shipping	One box, 27″h x 29″w x 11″d, 75 lb shipping weight, via Small Parcel
Assembly	About 15 minutes, 3 steps
Origin	Made in Indonesia

The footprint is the first thing to check on an end table, and this one is a 24 inch square top at 22 inches deep, standing 22 inches tall. That height puts the surface at the side of most sofas and lounge chairs, close enough to set down a drink or a book without reaching. The top itself is a square with softly rounded corners, so the table keeps a clean modern outline while losing the sharp points a true square carries into a walkway. Two arched slab legs carry the top, and because the support is a pair of solid panels rather than four posts, the profile reads as one sculptural block from across the room.

Weight does real work here. At 75 lb the Elora is far heavier than a typical side table, and that mass is the point: the table stays exactly where it is placed instead of drifting when a sofa cushion shifts against it. The published weight capacity is 138 lb, well beyond a lamp, a stack of books and a drink. It ships flat in one box via Small Parcel, the carton measuring 27 inches high by 29 inches wide by 11 inches deep at a 75 lb shipping weight, and assembly runs about 15 minutes in 3 steps.

Mahogany and Ash Veneer Under a Wire Brushed Jet Finish

The build pairs mahogany solid wood with ash wood veneer. The Jet finish is a dark NC lacquer with a wire brushed texture, a treatment that opens the ash grain so it stays visible under the dark surface instead of disappearing beneath it. In a room with pale upholstery the near black tone gives the seating group a hard edge to lean against, and in a darker room the brushed grain keeps the table from reading as a flat black box. The rounded corners carry the same finish over the edge, so the top reads as one continuous surface from every angle.

Care for the Lacquered Ash Surface

Wipe the wood surfaces with a soft cloth, dry or slightly damp, and dry the table straight after. Coasters belong under drinks and pads under anything hot or abrasive, and the lacquer holds up best out of prolonged direct sunlight. The table is covered by a 1-year limited warranty against defects in materials and workmanship from the date of delivery.

Frequently asked questions about the Elora square end table

How big is the Elora square end table?

It measures 24 inches wide by 22 inches deep by 22 inches high, weighs 75 lb and is rated to a 138 lb weight capacity.

What is the table made from?

Mahogany solid wood with ash wood veneer, finished in Jet with a dark, wire brushed NC lacquer. It is made in Indonesia.

How does it ship and how long does assembly take?

It ships in one box via Small Parcel, carton 27 by 29 by 11 inches at 75 lb shipping weight. Assembly takes about 15 minutes in 3 steps.

Where does a square end table work best?

Beside a sofa or lounge chair, where the 22 inch height lines the top up with the seat beside it and the rounded square top holds a lamp, a drink and books within reach.

Carry the same profile to the entry with the elora ash wood console table in jet for a matching entry piece, or browse more elora jet black occasional tables for modern living rooms at KF Rooms.